ARDEX P 52

  • Very low emissions
  • Solvent-free
  • Dilutable with water

Need personalised advice?

Contact us
€ 125,06 incl. VAT

Dispatched tomorrow

  • In-stock items dispatched tomorrow!
  • Orders of €1,250 or more qualify for free delivery.
  • Pay your way with iDeal or Bancontact

Product information

ARDEX P 52 is a primer concentrate for indoor floors, walls and ceilings. It can be diluted with water and used as a primer, bonding agent and pore sealer. It prepares substrates before applying levelling compounds, smoothing mortars or other finishes.

The primer binds residual dust and powdery particles and helps regulate suction. As a pore sealer, ARDEX P 52 prevents air bubbles from rising from the substrate and slows the premature loss of mixing water from levelling coats applied later. This provides a better base for a flat, stable finish.

ARDEX P 52 is suitable for cement screeds, concrete floors, smooth and dense substrates such as terrazzo, sandstone, tiles and boards, and existing substrates with well-bonded levelling compound and floor covering adhesive residues. It can also be used on smooth concrete walls and ceilings as a bonding agent for gypsum-based wall levelling compounds.

Application instructions

  • The substrate temperature must be above +5°C.
  • Outdoor use and use in permanently wet areas are not recommended.
  • Drying time is approximately 90 minutes to 3 hours, depending on substrate absorbency and site conditions.
  • On existing substrates, levelling compound and adhesive residues must be water-resistant, sufficiently load-bearing and firmly bonded to the substrate.
  • Where polyurethane-, epoxy resin- or bitumen-based adhesive residues are present, ARDEX P 82 must be used as the bonding agent.
  • Reseal opened containers tightly and use the contents promptly. Store upright and protect from frost.

Step-by-step guide

  • Ensure the substrate is dry, firm and free from dust and separating layers.
  • Pour ARDEX P 52 into a clean bucket and mix with water at the correct dilution for the substrate.
  • Apply the primer evenly with a suitable brush or roller.
  • Allow the primer to dry until a clear, thin film forms.
  • Only then proceed with subsequent work, such as levelling or bonding.
  • Choose the correct mixing ratio for the substrate, such as undiluted, 1:0.5, 1:1, 1:3 or 1:5.

Reviews

0,0 / 5 (0 reviews)

Rating

  • 5 stars (0)
  • 4 stars (0)
  • 3 stars (0)
  • 2 stars (0)
  • 1 star (0)
Write a review
Write a review

Your email address will not be published. Required fields are marked *

All reviews

There are no reviews yet.

ARDEX P 52

  • Check Very low emissions
  • Check Solvent-free
  • Check Dilutable with water
125,06 incl. VAT